She made two shapes for her skin, I was going to repeat it again, but suddenly I was thinking can I combine those two shapes into one metal sheet? so it would be a more interesting shape.
1. Roughly cut the metal to this shape
2. Because the middle part suppose to bend inward, so use anything you can find to support the side part. This is the way I found to support it and use the Bossing Mallet to hit it.
3. Refine the shape by using a small hammer, all you need is patience and any support with a good angle. If your template is assembled strong enough, don't forget to use it as your support unless you cannot find a good one
No comments:
Post a Comment